Solar Generator for Home Backup: How to Choose One

Emir Berisha Published 20 Nov 2026 · 5 min read
Solar panels standing in a meadow behind tall pink wildflowers on a bright day
At a glance
  • A solar generator is a portable power station plus solar panels; there is no engine and no fuel.
  • Size it from the devices you want to keep running, in watt-hours, not from the panel wattage.
  • For backup, check the switchover time (UPS or EPS), the continuous output and the battery chemistry.
  • Powering house circuits needs a changeover switch fitted by a qualified electrician, never a lead into a socket.

A solar generator sounds like one machine, but it is two: a portable power station and a set of solar panels. For backup, the battery and inverter decide what stays on in a power cut; the panels decide how fast you recover. Here are the choices in the order that matters.

What a solar generator actually is

Jackery describes a solar generator as a portable power station that uses solar panels to turn sunlight into electricity. The station holds the battery, charge controller and inverter; the panels only charge it, so you can buy the two parts separately.

It also means a solar generator is not the same as an installed home battery. A portable power station powers what you plug into it. An installed home battery is wired into your consumer unit and can run the whole house, or a set of circuits, by itself. Still undecided? See power stations versus plug-in batteries.

Step 1: list what must stay on

List what you really need in a power cut: fridge, router, phone chargers, some lights. Multiply each device's watts by the hours you want it to run; the total in watt-hours is the minimum usable capacity.

Illustrative example: a router at 15 W for 10 hours is 150 Wh, lights at 30 W for 5 hours are 150 Wh, and a fridge that averages 60 W over 10 hours is 600 Wh. That adds up to 900 Wh. Allowing for inverter losses, a station of around 1,000 to 1,200 Wh would suit that list. Each power station page on HomeBattery.com has a calculator for this sum.

Good to know

Charge from the mains when a storm is forecast; solar then only has to top it up.

Step 2: check the specs that matter for backup

  • Continuous output in watts. It must exceed everything you run at once. The EcoFlow DELTA 2 lists 1,800 W.
  • Surge power. Fridges and pumps draw a burst at start-up; see surge power and motor loads.
  • Switchover time. A fast UPS or EPS function keeps a router or computer running when the grid drops. Makers quote under 10 ms for the EcoFlow DELTA 3 Plus and within 15 ms for the BLUETTI Elite 200 V2; see switchover times explained.
  • Battery chemistry and cycles. LFP (lithium iron phosphate) usually comes with thousands of rated cycles; see LFP versus NMC.
  • Expansion. EcoFlow says the DELTA 2 goes from 1,024 Wh to 2,048 Wh with its extra battery.

Step 3: match the solar panels to the input

The solar input on the spec sheet sets the ceiling. The DELTA 2 accepts up to 500 W of solar and the Jackery Explorer 1000 v2 up to 400 W, so adding more panel wattage than that will not charge either one faster. Check the voltage window too: see matching panels to the input.

Panels rarely deliver their label rating, and on a grey UK winter day they may give only a small part of it, so for a winter power cut the mains charge you started with matters most. For days on solar alone, read our guide to off-grid batteries and power stations first.

Step 4: decide how it connects to your home

The simple, safe way is to plug devices straight into the station. Never feed your house wiring with a lead into a wall socket: it can back-feed the grid and endanger network workers. ESB Networks in Ireland says a standby generator must always be connected through an appropriate changeover switch, installed by a registered electrical contractor.

Some larger units are built for this. EcoFlow says the DELTA Pro Ultra reaches house circuits through a Manual Transfer Switch that a qualified electrician must fit. Want the fridge or boiler circuit to run without leads? Get an electrician's quote for such a switch first. We could not confirm a single UK rule naming this case, so follow your electrician and BS 7671. Outside the UK, voltages and rules differ: check the version for your country and our country guides.

Questions to ask before you buy

  • What is the continuous output and the surge output, and do my devices fit both?
  • What is the solar input in watts and volts, and which panel connector does it need?
  • Can I add an extra battery later, and is a transfer switch supported for house circuits?
  • How long is the warranty, and does it depend on registration or the seller?

Common questions

Can a solar generator run my whole house?

Usually not. Even large units run only selected circuits through a transfer switch. For automatic whole-house cover, an installed home battery with backup suits better.

What size solar generator do I need for a fridge?

Multiply its average watts by the hours needed, add other devices and allow for losses. Check the surge rating too, for the compressor start.

Can I leave a solar generator plugged in all the time?

Many are designed to sit on mains charge as a UPS, but check your manual on long-term charging.

Sources

Written by

Emir Berisha

Technical Reviewer at HomeBattery.com

Covers installation, backup power and day-to-day battery performance for HomeBattery.com. Helping readers see past the spec sheet with hands-on, technical reviews.

More articles by this author

Want to know which battery size fits your home?

Use our free calculator to get a size, savings and payback estimate.

Open the calculator