UPS and Backup Switchover Times: What the Milliseconds Mean

Jack van Veldhoven Published 19 Nov 2026 · 4 min read
A laptop, desk lamp and mug on a wooden desk at night with city lights outside
At a glance
  • Switchover time is the gap between the grid failing and the battery taking over.
  • One cycle of mains power in Britain lasts 20 milliseconds.
  • Fridges, lights and chargers do not notice a gap of 10 to 30 milliseconds.
  • A desktop PC can restart if the gap is longer than its power supply can bridge.
  • A true online UPS has no gap at all, but most power stations are not built that way.

Many power stations and some home batteries list a "UPS" or backup switchover time, often between 10 and 30 milliseconds. It sounds instant, and for most devices it is. For a few, such as a desktop computer, the exact number decides whether it keeps running or restarts when the power goes.

What the number measures

When a power station sits between the wall socket and your devices, it passes mains power through while it is available. When the grid fails, it has to notice and start supplying from its battery. The switchover time is how long that takes.

British mains power runs at 50 hertz, so one full cycle lasts 20 milliseconds. A switchover of 10 ms is half a cycle; 30 ms is one and a half.

What makers quote

The figures on our product pages come from the makers. The Anker SOLIX C1000 Gen 2 and the EcoFlow DELTA 3 Classic list 10 ms. DJI says the Power 1000 V2 takes over within 0.01 seconds, which is the same 10 ms. The BLUETTI Elite 200 V2 lists 15 ms.

Some makers are vaguer or contradict themselves. EcoFlow's manual for the DELTA 2 says it switches within 30 ms and calls this a basic UPS function that is not zero milliseconds. Jackery's page for the Explorer 1000 v2 gives both 10 ms and under 20 ms. When the figure matters, use the larger one.

Which devices care

Most household devices ride through a short gap without noticing. A fridge or freezer compressor simply keeps its cold, LED lights may flicker, and phone and laptop chargers carry on because the device has its own battery.

A desktop computer is the usual problem. Its power supply stores a little energy to bridge short dips. Reviewers who test PC power supplies against Intel's ATX design guide look for a hold-up time of roughly 16 to 17 milliseconds, and the newer ATX 3.1 guide allows less at full load. A switchover of 10 ms is usually fine; 30 ms can make the PC restart and lose unsaved work.

Routers, network storage, boiler controls and aquarium pumps vary by model. If one restarts after a short gap, it may come back on its own, but a device that holds an important setting or a long job is worth testing.

Power stations, true UPS units and home batteries

An online or double-conversion UPS runs your devices from its inverter all the time, so there is no switchover at all. Most power stations instead pass mains power straight through and switch when it fails, which is why they quote a time. A power station is therefore not a full replacement for a dedicated UPS on equipment that must never blink.

Installed home batteries handle backup in a different way: through a backup gateway or a separate backup socket, and some do not provide backup at all. Our guide to whole-home battery backup explains the set-ups.

Test it before you need it

Plug the device into the power station, plug the station into the wall, then switch off the wall socket. Start with something you can afford to restart. If the device survives several tries, the switchover is short enough for it. Never test with medical equipment, and do not rely on a power station for life-support devices.

Common questions

Is a power station the same as a UPS?

Not quite. Many power stations offer a UPS-style function that switches to battery within 10 to 30 milliseconds. A true online UPS has no gap at all because it always runs your devices from its inverter.

Will my desktop PC stay on during a 30 ms switchover?

It may not. PC power supplies are tested to bridge roughly 16 to 17 milliseconds, so a 30 ms gap can cause a restart. A 10 ms switchover is usually short enough.

Does switchover time matter for a fridge?

No. A fridge or freezer keeps its cold through a gap of a few milliseconds and simply carries on when the power returns from the battery.

Sources

Written by

Jack van Veldhoven

Market Analyst at HomeBattery.com

Covers pricing, market trends and policy across the European energy storage market for HomeBattery.com. Helping readers see how their options stack up with clear, practical comparisons.

More articles by this author

Want to know which battery size fits your home?

Use our free calculator to get a size, savings and payback estimate.

Open the calculator